Just received a Bachmann DCC Spectrum train set. In setting it up I have a problem in that there appears to be no current reaching the Dynamis Command Station. There should be LEDs showing when the system is plugged in but the unit remains "in the dark." Is the problem likely with the transformer/adapter or with the Command Station?
As one that does not use that make of a DCC system all I can come up with is.
After you have read the instructions and it does not work then get some else to also read them.
If you both come up with the same results then most likely some part is defective. It happens. :o
Most likely some one else will give you some information that will help.
Make sure the IR unit on the top is plugged in completely with no bent prongs. Also check your power supply with a volt meter to see if it is working.
Kevin
Some DCC systems are finicky about setting the components up and plugging them in before you apply power from the outlet. Might be a factor!
I have a Dynamis but these days only use it for programming decoders occasionally,
However a couple of pointers I assume you have fitted batteries and they are correctly aligned as per instructions and they are inserted the correct way round (+ & -)?
Have you switched the switch on the control unit to ON?