I would like to run two separately controlled loops of E-Z Track, connecting them with the use of an E-Z Track Crossover Turnout. However, it appears that there is no rail gap or place for an insulated rail joiner between the switches of each "mainline." Is there a built in "gap" to isolate one track from the other that I cannot see? There is nothing in the description about this.
Other than cutting a gap in the rails between one track and the other with a Dremel cutting disc, is there another way to do this?
Would I be better off to buy two Right Hand or Left Hand switches for my layout and insert insulated rail joiners or cut a gap using them?
MrStumpy
Other than cutting a gap in the rails between one track and the other with a Dremel cutting disc, is there another way to do this?
Would I be better off to buy two Right Hand or Left Hand switches for my layout and insert insulated rail joiners or cut a gap using them?
MrStumpy