Hi all,
My Spectrum 2-8-0 kit bash is progressing but I've decided to replace the front pilot coupler with a Kadee. Will a #5 work OK? I'd also sure appreciate advice on the best (eaiest :)) way to remove the existing coupler and install the Kadee ... hopefully with a minimum or 'no' cutting?.
Thanks!
lanny nicolet
Lanny,
The best way to put Kadee coplers on Bachmann Spectrum steam is to use the fairly new Kadee #148.
It is a "wisker" spring coupler just like the Bachmann coupler so it is basicly a drop in replacement. You may have to file the coupler open just a bit because the Kadee coupler is a little thicker, but that should be about it.
the coupler is held in place by a spall clip, just spread the side arms of the clip and it will pop out. Slide the new #148 coupler in, check the fit, and reinstall the clip.
Sheldon
Lanny,
P.S. I received your e-mail and your instructions are on the way.
Sheldon
Hi Sheldon,
Thanks for the advice on the coupler for the 2-8-0. I'll get one of the Kadee #148s from my LHS and install per your instructions.
Thanks, also, for sending the passenger car instructions that you used in your demonstration/clinc. Appreciate the help!
lanny nicolet