I've hard wired mine too when I changed the decoder . But the draw bar form a Lt Mtn. will work , it's the same as the 2-8-0 .
Please read the Forum Code of Conduct >>Click Here <<
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: Hunt on May 29, 2016, 08:46:53 AMQuote from: Mike C on May 28, 2016, 10:34:15 AM
Which DCC system are you using ? If you have Easy DCC I don't think that you can do any CV changes , But if you have Dyanimis , or an NCE or Digitrax system you can just go into program mode to bring up CV 8.
EasyDCC is made by CVP Products and is capable of programming all CVs.
E-Z Command Control Center is Bachmann DCC system and it is not capable of programming by user supplied CV number.
Quote from: Jimthomason on May 28, 2016, 09:56:12 AM
How do I reboot the decoder?
Jim
Quote from: Rheingold on April 27, 2016, 04:50:46 PM
Which decoder could I buy to replace the built-in decoder?