Ok, I may sound like the other guy that had problems with the turntable. I'm able to run the table with dc, but not with my DCC (NCE). Looks like the only way to run this turntable is with a complete Bachman system.
There is an 8 pin socket on the board under the shed. Any brand decoder with an 8 pin plug will work.
greetings
you will need a bachmann decoder or one of your choice so you can program the turntable like you program an address for your loco.i believe the turntable comes complete with wiring &a dummy 8 pin plug, just remove the plug and replace it with a decoder and give it an address like you would a loco and every time you want to access the turn table punch in the address for it and you will have control. you will also be able to toggle back and forth between the tt&your loco by using the recall on your nce as you do have 6 slots for addresses if you have the latest
update on your nce power cab.
regards&later KEWATIN