I have a new Santa Fe #3507 GP40-DCC equipped. Well anyway I bought it new but I do not have any instructions with it. When I run this engine it starts out really smooth and then after a couple of minutes it gets really noisy. It might need lubrication however I do not know where to lube it at, so are there any on line instructions or any thing on this engine? I have three engines similar to it so please help. thanks Jack
I doubt lubing will be necessary as they are pre-lubed from the factory. Try running it in forward and reverse for a while which should break it in. If you still want to go inside snap the fuel tank off and there should be 2 or 4 screws under that. After removing the screws lift off shell.
Always remember too much lube is not good.
Jerry