I purchased a #6 turnout and followed the directions.Everything programmed as it was supposed to but,the switch does not toggle back and forth when I hit either direction button.
Which system are you using. Did you try to repeat your steps? Explain what steps you took.
Here's a link that might help
http://www.bachmanntrains.com/home-usa/ez_content/EZ_Command_DCC_Turnout_Instructions.pdf
Jerry
I'm using the ez command system. I went in and followed those directions .When I finished programing the switch cycled 4 times telling me it was programed successfully. Now,how is the switch supposed to toggle back and forth.I thought you pushed the forward and reverse arrows to toggle it ---nothing
You missed a step, I have mine programmed to a different address, so yours is probably still programmed to #3. Just like activating sounds on your loco's you have to press the function key and then press the key assigned to toggle them.
Try addressing #3 press function then press the keys till you find the one's that toggles them. You can readdress them to different numbers if you wish.
Jerry
It's been a while since I programmed mine But try pressing #9 and the function key. I believe you forgot to set the address button for the position of the points.
It will time out after a few seconds so don't wait too long
Does anyone have any experience (good or bad) programming and controlling the E-Z Track DCC Onboard turnouts with a Digitrax DCC system? I've done it but the problem is that the turnouts don't retain their address; I wind up having to reprogram them about every other time or so that I use the system.
Tech support at bot companies keep pointing the finger at the other company and are of zero help.