Thanks very much.  I worked for the CPR for 37 years, but have only been doing "Model Railroading" for a year.  I only have 2 locos.  I am trying to do double track and supply power to both tracks with one EZ Controller.  Any Ideas?  Do I use a crossover track?  Thanks Len,

Jeremy from Alberta.

I am extending my layout and would like to know how much length of track can one EZ Command Control Center Power?   Thanks very much!

Thanks very much for the help 👍

Or hunt

Thanks very much.  So I will have to remove the spade from the green Wire?  It is a 3 strand wire so I put the outer most wires in to the posts?  Also I can only us one controller per switch?  Thanks again Flare.

I have the DCC Command Center and the Bachman Power Pack and Speed Control.  However I cannot figure out how to connect the remote switches.  The Controllers are connected fine.  Can anyone let me know the step by step instructions to get
these switches working?

Thanks!

Ok.  Thanks!

AHHH, finally someone who knows!  Thanks so much.  The side switch was included.  But I do not have the analog controller.  I will now go get one.   Thanks very much again and Merry Christmas From Alberta!

But the package says "Remote Turnout".  It says "a three-wire green cable with plug is attached to the track section.  Insert plug end of the green cable into the "turn-out controller".  Is this a separate controller I need to buy?  Thanks very much.

They have green wires attached. 

I have recently purchased the Digital Commander deluxe set.  I am trying to add remote turnouts, but cannot get them to work.  Yes I am new to Model Railroading, but retired with 37 years at CPRAIL.  I checked
you tube but the fellow says to push a button on the turnout, and then function 9 on the controller. However my Bachman remote turnouts have no button to push?

Can anyone help me step by step to get these turnouts to work?  All I get is the controller flashing and beeping.

Thanks very much!