I have a Bachmann N scale 2-6-0 locomotive which is DCC equipped. I have been running it on DC for several months, and recently tried it on DCC. It worked intermittently at first, and now won't run on either DCC or DC. I tried resetting by writing 8 to CV 8 but that has done nothing.
Is there a procedure to diagnose or manually reset the DCC controller, or must I buy a new one to find out if this one is ruined?
Walt
Walt,
What DCC controller are you using?
Actually, I meant to ask about diagnosing the decoder, not the controller.
I'm using a DCC++ Arduino based controller. I finally sent the loco back to Bachmann, since it has a loose traction tire that needed fixing anyway.
Thanks for replying :)
Walt