I was thinking earlier, a lot of these requests in wishlists will proberly be ignored, so why not have a go yourself? Faces wouldnt be hard to do, get some milliput and mould faces, then stick them on the desired stock. An easy one would be spitful brakevan, get a bachmann UK 20 ton brakevan and mould a face on the one end, job done! There are others that are easy while sme more could be a little difficult, Harvey, Lady etc. I am going to attempt the prototype on which Harvey is based on though, hopefully it will turn out alright.
Good luck on your project. :)
good luck 7029cluncastle. mind if i just call you clunc?
I think the Great Western Railway would get offended with Clunc ;) Kenny will do fine! :D
When i eventually get the project started i will post progress and such like on here for you all to see.
It's pretty easy to make stuff yourself once you learn a thing or two ;)
(http://i496.photobucket.com/albums/rr326/StanierJack/0246d246.jpg)
(http://i496.photobucket.com/albums/rr326/StanierJack/4df7db6b.jpg)
(http://i496.photobucket.com/albums/rr326/StanierJack/c5efcd87.jpg)
Jack
nice van. ;) where did you get the face from?
@Churchill8F, you're amazing.
The face for the van is it wooden or tomix?
That face is from some rare TTTE product & 7029cluncastle,Milliput can also be used to make some locomotive body parts & details.
Jack, your Rheneas is the ERTL model correct? I have one of them awaiting a motor so least i know it has been done! I also have a Rusty awaiting a motor too.
No, the face is only ERTL. I'm pretty sure he used an 009 Dolgoch model? :)