Ok.
Took a break from running my new Big Hauler Version #7 4-6-0 with DCC and Soundtraxx TSU-4400 sound.
So, I finally decided to take an in-depth look at the mogul to see if I could figure out its' headlight issue.
Disassembled the tender and checked for a loose/broken wire.
All good.
Pulled the TCS 1525 21 pin sound decoder board to check for a possibly bent pin on the motherboard.
No problems there.
Had noted before pulling it that the decoder was not completely set all the way down on the pins.
Made sure that it was properly aligned and set on the motherboard after reinstall.
Removed all 4 wheel sets,cleaned all 8 wheels and lubricated the axles.
Reassembled tender.
Connected to locomotive and placed on tracks for testing with NCE Powercab.
Worked flawlessly, thusly answering my own question.
Mike
Thanks!
Took a break from running my new Big Hauler Version #7 4-6-0 with DCC and Soundtraxx TSU-4400 sound.
So, I finally decided to take an in-depth look at the mogul to see if I could figure out its' headlight issue.
Disassembled the tender and checked for a loose/broken wire.
All good.
Pulled the TCS 1525 21 pin sound decoder board to check for a possibly bent pin on the motherboard.
No problems there.
Had noted before pulling it that the decoder was not completely set all the way down on the pins.
Made sure that it was properly aligned and set on the motherboard after reinstall.
Removed all 4 wheel sets,cleaned all 8 wheels and lubricated the axles.
Reassembled tender.
Connected to locomotive and placed on tracks for testing with NCE Powercab.
Worked flawlessly, thusly answering my own question.
Mike
Thanks!