I HAVE AN EZ COMMAND DECODER INSTALLED ON MY BACHMANN TURNTABLE BUT I DON'T KNOW HOW TO REPROGRAM IT. I ONLY WANT TO REPROBRAM THE ADDRESS. I KNOW IT IS IN CV01 BUT HOW DO YOU GET ACCESS TO IT. IT DOESN'T WANT TO RESPOND TO NORMAL DIGITRAC TECKNIQUES LIKE OPS PROGRAMING. ANY HELP WOULD BE APPRECIATED.I HAVE A DIGITRAC DCS 50 CONTROLLER.
JOEV

CAN I PROGRAM BACHMAN DECODERS WITH MY DIGITRAX PROGRAMER? WHEN I ATTEMPTED TO REPROGRAM THE ENGINE NUMBER ON A BACKMAN DCC ENGINE I GOT A WIERD RESPONSE WHEN I TRIED TO READ OUT THE EXISTING NUMBER. THANKS FOR ANY HELP.
JOEV

I HAVE SOME QUESTIONS ABOUT THE BACHMANN MOTORIZED TURNTABLE 46299. I PLAN TO OPERATE IT WITH DCC CONTROL. HOW DOES THE POWER GET TO EACH INDEX TRACK AND TURNTABLE? DOES ONLY ONE TRACK AT A TIME GET ENERGIZED? IF SO, HOW DO YOU REVERSE THE DIRECTION OF THE ENGINE ONTO A SIDING OR ROUNDHOUSE?

I PLAN TO USE STRAIGHT 9" SECTIONS OF E-Z TRACK TO ATTACH TO THE INDEX SECTIONS. I ASSUME THEY WILL BE ENERGIZED WHEN THE TURNTABLE REACHES EACH POSITION AND NO ADDITIONAL WIRING IS REQUIRED. IS THIS CORRECT?

WHAT DOES THE MOTOR SOUND LIKE? MY PREVIOUS EXPERIENCE WAS WITH A ATLAS TURNTABLE AND THIS WAS QUITE NOISY. IS THIS ANY QUIETER OR SMOTHER SOUNDING?

JOEV