The loco runs fine on DC and DCC (light works, it pulls well, creeps, etc.); however, just recently, when I turn on the DCC system I hear a little squeel like hum, and sometimes, the locomotive will start to crawl on its own even though the throttle is turned down.
If I throttle up and speed the locomotive up then back down to zero it will stop and sit, but the next time I turn the system on the locomotive will make the noise and move on its own.
I reset the decoder, but it still does it. Any suggestions???
If I throttle up and speed the locomotive up then back down to zero it will stop and sit, but the next time I turn the system on the locomotive will make the noise and move on its own.
I reset the decoder, but it still does it. Any suggestions???