Hi all,
I have installed a reverse loop on my layout with Cobalt switch machine and PSX-AR to control the polarity and the switch machine. Can anyone advise about current trip settings for J6 on the PSX-AR ?. When a loco reaches the gap in the loop it stops, sometimes my short circuit light comes on bright, sometimes just dull. Sometimes no light comes on, the switch changes and the loco restarts them moves off through the switch. I think it is to do with the current trip settings but don"t have enough "nouse" to work it out or courage to start experimenting blindly. I need an answer as simple as " put wire in A and connect to B " if that is possible. I run the usual Bachmann locos, 2-6-0, Forney, Davenport, Porters etc all on DCC.
Kind regards
Chris
I have installed a reverse loop on my layout with Cobalt switch machine and PSX-AR to control the polarity and the switch machine. Can anyone advise about current trip settings for J6 on the PSX-AR ?. When a loco reaches the gap in the loop it stops, sometimes my short circuit light comes on bright, sometimes just dull. Sometimes no light comes on, the switch changes and the loco restarts them moves off through the switch. I think it is to do with the current trip settings but don"t have enough "nouse" to work it out or courage to start experimenting blindly. I need an answer as simple as " put wire in A and connect to B " if that is possible. I run the usual Bachmann locos, 2-6-0, Forney, Davenport, Porters etc all on DCC.
Kind regards
Chris