Print Page - Analog on EZ Command

Title: Analog on EZ Command
Post by: SteveB on July 25, 2009, 04:06:15 PM

How can I run a analog Porter 0n30 on my EZ Command system?

Title: Re: Analog on EZ Command
Post by: Jim Banner on July 25, 2009, 11:23:56 PM

Use address 10. Details are in your E-Z Command manual.

Expect the locomotive to be noisy. Running the locomotive on a DCC system should not hurt it but leaving it stopped on a DCC powered track may. Some DCC systems, including E-Z Command allow you to run one analogue locomotive along with your digital locomotives, but the system for doing so is less than ideal. If you are running this locomotive by itself, you would probably be happier running it on dc. If you are running it along with digital locomotives, you would probably be happier if you installed a DCC decoder.

Jimi

Title: Re: Analog on EZ Command
Post by: SteveB on July 25, 2009, 11:30:50 PM

Thanks for the help. I will give it a try.

Bachmann Online Forum

Discussion Boards => General Discussion => Topic started by: SteveB on July 25, 2009, 04:06:15 PM