Hi. I have an RS3 with factory value sound that I need some advice on. I use a Digitrax Zephyr for my control station.
The unit has not been run in 7 or 8 months. It now seems to be stuck in the "quiet mode" according to what I read in the Bachmann/soundtraxx web pages. The sound works fine when forward or reverse is selected and the throttle set at 15 or above. Moving to brake or setting the throttle to zero causes the sound to slowly shut off.
I have programmed factory reset using both CV8-8 and CV30-2 and received the blinking lights but no sound as per the instruction manual. I tried both direct and ops programming modes. According to the manual the problem should be solved by setting CV113 to zero, which turns off the quiet mode. This didn't help.
I hope someone has worked through this before and can offer some advice. Thanks.
Steve
The unit has not been run in 7 or 8 months. It now seems to be stuck in the "quiet mode" according to what I read in the Bachmann/soundtraxx web pages. The sound works fine when forward or reverse is selected and the throttle set at 15 or above. Moving to brake or setting the throttle to zero causes the sound to slowly shut off.
I have programmed factory reset using both CV8-8 and CV30-2 and received the blinking lights but no sound as per the instruction manual. I tried both direct and ops programming modes. According to the manual the problem should be solved by setting CV113 to zero, which turns off the quiet mode. This didn't help.
I hope someone has worked through this before and can offer some advice. Thanks.
Steve