Hello everyone.
I purchased a 6940 Union Pacific item number 65153 DCC Sound Value On Board.
Using a digital Intellibox II.
It all works fine except when quickened, as well as some voltage, the locomotive suddenly block. I read that we must be careful not to give too much power when it is used in analog mode.
But I use it in digital.
Should I adjust some CV?
Someone could help me?
Thank you in advance.
Luca Vianini
Can you rephrase your question sir? I'm having a hard time understanding what kind of problem you're having.
If I had to guess, it sounds like it stalls out at high speeds when run on DCC. As for why...?
Cheers,
-Mark
Program CV 8 to 8
Turn Intellibox II power off
Wait 15 seconds
Turn Intellibox II power on
Make no changes to locomotive
Program CV 29 Bit 2 to 0
Run locomotive using address 3
Are the reported problems gone? If so you can now change to the address you wish to use.
...when I accellerate too mutch, the locomotive have something stop working.
What is the transformer AC voltage output to the Intellibox II?
Does the locomotive stop running when using the Left Controller, Right Controller or either controller.
Does the locomotive run without stopping with the Intellibox special options (SO) set to only use the DCC format?
SO # 25 = 1
SO #907 = 4
SO # 22 = 0