After running my engines in a consist, I am having trouble reprogramming two of my dcc equipped bachmann diesels to their original addresses. Also, I tried to assign another loco to a different address without luck. Never had this problem before. Have done it many times. I am using bachmann equipped diesels from manufacturer and bachmann e-z command control. Is there a problem with the e-z command controller?
A few thoughts -
(1) are you programming on the main or on a separate programming track? It shouldn't make a difference but ...
(2) did you consist the locomotives using your E-Z Command? If so, and you are trying to reprogram them on the main, you may be addressing two locomotives at once.
(3) did you consist the locomotives using a different type of command station (at a friend's house or at the club?) If so, they may be consisted in a way that the E-Z Command cannot unconsist.
(4) are you using the instructions in the manual or on the DVD? The latter are correct.
Jim
1. On the main 2. Used e-z command, one loco at a time 3. no other command station used. 4. used manual, but will recheck the dvd. Thanks mucho for your info. Duane