I'm in the midst of planning a 30"x54" N scale layout using Atlas Snap-Track and remote Snap-Switches. I see that the remote switch machines can be strung together for easier access, and I plan on doing so.
However, the wires from the manual to the remote switch machines (and from the machines to the power pack) only run so far... and, as can be seen in the hypothetical plan here, I have two switches on the side opposite where the main switch panel–consisting of said joined-together switch machines–will be located... my question is, it possible to have two separate panels and have them wired to the same AC connection on the power pack?
Main power-pack connections are denoted by thick lines. Green track sections are flextrack/cut to fit.
However, the wires from the manual to the remote switch machines (and from the machines to the power pack) only run so far... and, as can be seen in the hypothetical plan here, I have two switches on the side opposite where the main switch panel–consisting of said joined-together switch machines–will be located... my question is, it possible to have two separate panels and have them wired to the same AC connection on the power pack?
Main power-pack connections are denoted by thick lines. Green track sections are flextrack/cut to fit.