Hey,
I'm wanting to upgrade my Thomas to run on my DCC layout and I was just wandering if I need to remove the 103 yellow resistor before I solder the decoder to it? I'm using a digitrax DH126 decoder if that helps any.
Thanks
Hi there,
I found this video helpful for my first Bachmann Thomas & Friends conversion. I recently converted Duck. I am not sure about the "103 yellow resistor", but as you'll see in this video you need to cut away the existing circuit board. Good luck!
https://www.youtube.com/watch?v=1JK_nB7mU-U
Yes, but that yellow 103 resistor is actually a filter capacitor, you should remove it if you would like to properly convert your Thomas to DCC, otherwise it could cause intermittent running issues.