Hi all!
OK, so I am my own worst enemy ! I just got a Heisler ( LOVE IT !!) and that prompted me to try DCC with a Dynamis starter kit.
As they say,a little knowledge is a dangerous thing ! After getting the system hooked up and reading Steve Lewis's info I was able to reset the CV' s to get the Heisler lights working properly. Hey this is great !
So I then proceed to reinstall the decoder in my inside frame 4-4-0 ...... and it won't run. Well, I try messing with the CV' s and still nothing. OK, so let's try ANOTHER never used decoder from a rail truck .... still nothing. Hmmm.... double check the plugs from the tender to the loco ... nope. Well, let's try changing the loco address ! Wrong again ! Wiggle the wires from the tender and WE HAVE LIFE !!!! Sort of.... only wants to run in one direction regardless of signal from controller and no lights. Messed with the CV' s again ...some people just never learn !
OK, let's take decoder #2 and put it in a different loco - a Climax. Same symptoms, no lights and only runs in one direction regardless of controller input.
Sooo....let's try ANOTHER never used decoder in the Climax. And it works ! Forward, reverse.... but no lights . OK, so I put that decoder into the 4-4-0 and yes we have forward and reverse, but no lights.
So here we are,faced with two problems : 1) any ideas what I need to do to get the lights working ? and 2) does anybody know what the default settings are to restore the first two decoders or where I can get them ? Better yet, is there a shortcut to restore them ?
Your help would be greatly appreciated and comments about my ineptitude will be accepted accordingly ! :o
Rick Gannoe
1st question. Are you putting the decoder plugs in the correct orientation? Pin 1 must go in socket 1
First thing to do with dodgy decoders is to do a decoder factory reset it is usually done by entering the value of 8 in CV number 8.
This will set the decoder to the values it was at before it was ever used, and note it will set the address back to number 3.
If this works ok you can then programm the decoder to the required address and enter some values for acceeration and deceleration,,, more often than not it is usually not nescessary to alter any other CVs
For info the CV for acceleration is 3 and decelaration 4.
I usually set CV 3 to around 25, and CV 4 to around 12, then on testin how the loco runs at these settings adjust the settings upwards or downwards.
I am holding out for RC control..No track wiring! 8)
Royce
THANK YOU Chris and Steve !!!!!
Good call Chris, I reversed the plugs and got lights ;D !
Reinstalled decoders #1 & 2 to see what I had and one worked fine ( put it in a rail truck and was able to give it a new address), but the other one went crazy ! The truck took off full throttle in one direction, stopped and reversed direction all by itself !
Steve, I'm going to follow your direction and see if that decoder can be saved. I am sure that will work.
Thanks again ! :D
Rick G
PS: I really DO have 3 railtrucks with NO broken gears ! Also 2 Climaxes.