News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Mark 1806

#1
HO / Dcc turnout issues
December 24, 2018, 11:43:07 PM
 I have 2 new ez track dcc turnouts that do not respond when I press the set program button. It is an oval with two turnouts that form a figure 8 so to speak. It is fed by 1 red wired track feeder. It says to hold the button in and wait for it to click, nothing happens. Do I need to put feeder wires right on the turnout? Any ideas would help.