I know how to program the turnout with Dynamis to get it to work.
I got that after reading the posts.
I have 2 turnouts
DCC Turnout Left - 44130
DCC Turnout Right - 44131
Once programmed the Diverge / Straight is reversed on the Dynamis System.
I have looked through the posts and saw questions on this from over a year ago.
Has anyone found out since last year on how to fix this?
The instructions state on how to reverse with E-Z Command but not with Dynamis.
I can not believe that within a year it has not been resolved.
I also cannot believe that Bachmann does not have instructions on this and on how to program it yet in the box or online.
If it can not be done can you reverse the wires on the solenoid?
If so which wires are they?
Depending on which turnout I look at, there is a brown, grey and a red on one / orange on the other to the solenoid.
Which wires do I reverse? The grey and the brown?
11 Mar 2011
I have solved the issue.
The switches now work correctly with the Dynamis system.
I'm having the same problem with the straight/diverge icons being reversed while using the Dynamis system to control turnouts 44130 and 44131. Did you have to reverse the wiring on the turnout's solenoid? Or is there a programming fix using the Dynamis Pro controller?
Any help you can give would be greatly appreciated.
Thank you,
Orvis
P.S. I have two Bachmann DCC Crossover Turnouts (No. 44137 & 44138) and those programmed okay. The diverge/straight icons display correctly.
To solve:
Reverse the wires on the decoder.
Reverse the brown and grey wires. Not the red / orange.