Hi again, sorry but preemptive text changed my previous post...
Should have read... Is the roco Z21 system compatible with Bachmann ezitrack dcc turnouts?

Good morning
Am looking at the roco Z21 system as a replacement for my dynamis controller , is the Roco  system compatible with Bachmann  svc exit track turnouts?

Hi all
I use ezitrack with dcc turnouts and dynamis controller.
How hard is it to install track signals?
Do Bachmann have any ready to install products available?
Kind Regards

Hi All ,  I am building a totally  dcc layout using dynamis and ezitrack (with dcc turnouts),  would like to include automated block signals into it..
What is available ? Are there any block signals that can simply plug into the existing turnouts?
Your input and experience will be greatly appreciated.

Good morning, have sent emails to both parts and service  (including one to wallaceb@bachmanntrains.com , this address I  found in the forum , and received an incorrect address notification when i sent it.).so far I have had no response  (s) ,  I am in Australia  and  would like some contact information please.

Hi ,  am considering using the N scale auto reverse set as a mining operation on a larger scale build.
What are the requirements for the Loco  ,  dc/dcc ,  can't find any relevant information.
Thanks and kind regards
Marshall Spencer

Hi , am using Ezitrack nickel silver , what is the best way of laying down ballast on this type of track (HO) especially on and around turnouts (full DCC).
Thank You

Hi , I have a Dynamis operating system , all my turnouts are DCC operated , when I go into the programming mode , everything goes as per the instructions. When I turn the controller off to save battery power and turn back on again, all saved addresses for the turnouts appear to have been wiped out... what step am I missing.

I have a Spectrum DCC and Sound , Baldwin 2-8-0 consolidation with medium tender #84509 , the leading tender truck does not want to keep sitting squarely on the rails , possibly the DCC wiring harness is lifting the front of the tender , or there is not enough weight in the tender ...any ideas guys ?

Thank you  , shortly after I sent this message , I inadvertently held one of the short sections of track supplied with the turnouts up to some light and found the cutout markings..
Stupid me...

Hi Mr.Bachmann , I have recently purchased some 44132 and 44133 DCC E-Z Track turnouts , when fitting other track components i.e. 44511 straights , have found that the roadbeds, foul on the track beside it .. Question is do I have to trim the roadbed on both tracks , if so , by how much and at what angle is recommended ?

Hi , these look quite interesting , what size layouts are we looking at and what are the E-Z track components?
are the turnouts DCC and is there room for a turntable?
Spencer

Hi Morgun , thanks for the reply , am open to options , the layout framework and subsequent top , will literally be clamped to a small table , approx. . 1200mm long x 765mm wide.
Regards
Spencer

Hi Joe , will keep looking at possibilities until track plans are posted , however to put you in the picture , Australia unfortunately uses metric materials , a standard sheet of ply is 1200mmx900mm , 47.25 x 37.5 inches ,my proposed tabletop will be 1200mm(47.25in) x 2700mm(106.25in).
hopefully plans will include a turntable and switching yards.
Kind regards
Spencer

HI , have recently purchased a Spectrum/Dynamis Starter set Maine Central #01403 and a catalogue #99978.Will be using an 8x4 area , purely for lack of any other useable room ..
The track plans/layouts in the E-Ztrack catalogue are minimal , I will be using nickel silver E-Z track , with DCC controlled turnouts etc.
Are there any other reference catalogues for suitable track plans available through Bachmann? have also downladed the "free version of Anyrail.com"
Thank you