Why does my system's turnouts forget their programmed settings whenever I program a new loco? What am I doing wrong?
- Welcome to Bachmann Online Forum.
News:
Please read the Forum Code of Conduct >>Click Here <<
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
HO / Switches (turnouts)
November 08, 2011, 12:18:33 PM
Whenever I program a new loco on my Dynamis DCC system the system
'forgets" the previously programmed switches(turnouts). Then if I reprogram all of the switches everything is fine. None of the previous loco programs are affected. Is this just the way it works or am I doing something wrong? I also note that when I press the numerical keys ( on the left of the panel of the Dynamis controller), the screen disply never just shows up as 0001, but as something like 0041 and I have to toggle thru w 0's to get to 0001 and activate that switch.
? Am I doing something wrong, or has my Dyamis system been invaded by an alien or is this just the way the system works. Otherwise everthng is fine.
'forgets" the previously programmed switches(turnouts). Then if I reprogram all of the switches everything is fine. None of the previous loco programs are affected. Is this just the way it works or am I doing something wrong? I also note that when I press the numerical keys ( on the left of the panel of the Dynamis controller), the screen disply never just shows up as 0001, but as something like 0041 and I have to toggle thru w 0's to get to 0001 and activate that switch.
? Am I doing something wrong, or has my Dyamis system been invaded by an alien or is this just the way the system works. Otherwise everthng is fine. #3
HO / "Wire Glue"
August 25, 2011, 11:23:55 AM
Anyone have any information re: "Wire Glue"? I'm thinking of using it on track joint joiners for continuity instead of soldering ALL of those joints.
#4
Am I correct in assuming that the isolated tail section of a DCC Wye that has an auto reverse module should NOT be connected back to a mainline track and simply terminate in a dead end?
#5
HO / Connections for Dynamis and 5 amp Booster
August 08, 2011, 12:19:04 PM
I cannot find any specific directions for the exact hookup between the Dynamis and the 5 amp booster. Pls specify exact connections from start to finish.
#6
HO / Dynamis connection
July 12, 2011, 10:31:10 AM
On the Dynamis Command Station, can I use both of the output connectors at the same time for connections to the track or must I use only one or the other? In other words, are they both 'hot' at the same time or does using one 'kill' the other?
#7
HO / electrification of WYE
June 06, 2011, 04:15:12 PM
to use a WYE for reversal of locomotive in DCC, EZ track, should this setup require a reverse loop module on each leg of the WYE? I have the main line horizontal, then have two turnouts (L & R) going up to the two curved legs of the WYE, then the straight leg going striaght up the length of a full train. After going thru the right turnout & then up the right leg of the WYE & straight up the full length of the train , I then reverse the train down the left leg of the WYE thru the left turnout to the mainline. Now the train is reversed.
Pages1