Ideas on how to resolve this issue of error codes 11 and 12 not able to progress until this is solved
- Welcome to Bachmann Online Forum.
News:
Please read the Forum Code of Conduct >>Click Here <<
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
N / accessory decoder MERG read and write errors on Dynamis any ideas on how to prog
September 19, 2016, 09:27:05 AM #2
N / Dynamis Pro Box connection to PC
November 22, 2015, 02:32:23 PM
I have recently added a Dynamis Pro Box to my layout It has been supplied with a round plug at both ends of the cable I need to connect to my PC which does not have a round plug socket only USB sockets Has anyone any advice as to a solution
Many thanks
Rob Lewis
Many thanks
Rob Lewis
#3
General Discussion / Re: Dynamis command station
June 30, 2015, 09:27:35 AM
Hi
I think I have solved the issue Have moved to a programing track and not main track and I now see action ie PROGRAMMING happening.
Many thanks
Regards
I think I have solved the issue Have moved to a programing track and not main track and I now see action ie PROGRAMMING happening.
Many thanks
Regards
#4
General Discussion / Re: Dynamis command station
June 29, 2015, 04:46:52 AM
To be able to understand if and when the instructions have taken effect as there seems to be no indication of any effect.
Reset works
Reset works
#5
General Discussion / Dynamis command station
June 28, 2015, 07:38:55 AM
Recently acquired the above system Set up ok but I am not able to make any changes to the CV's to suit my needs
Any assistance would be helpful
Running a Kato Gevo with Digitrax DN163k1c
Many thanks
Ritlew
Any assistance would be helpful
Running a Kato Gevo with Digitrax DN163k1c
Many thanks
Ritlew
Pages1