Hi Folks,
I have two Bachmann EZ Command DCC Equipped turnouts, with a Digitrax Super Empire Builder operating system. I cannot get the turnouts to program. I have followed the instructions for both Bachmann and Digitrax.
Suggestions?
Yours in Model Railroading,
John
Littleton, CO
Dear John,
Come visit us at the World's Greatest Hobby on Tour in Denver tomorrow. Digitraxx is here as well as Bachmann. I'm sure that your question can be answered by their techs.
Hope to see you tomorrow!
the Bach-man
Hi Bach-man,
Could not make the show. So, my question still stands.
Dear John,
So does my suggestion: contact Digitrax. They'll be able to help.
Sorry you couldn't get to Denver; it was a great show!
Have fun!
the Bach-man
You can see if your question is answered here: http://tsd.digitrax.com/ (http://tsd.digitrax.com/)-Digitrax Tech Support Depot Link
Or contact Digitrax by by email at: techsupport@digitrax.com
Folks,
I have contacted Digitrax Tech Support three times now. I have followed the Digitrax instructions on programming turnouts, but my Bachmanns will not program.
John
Well, I'm sorry, but a lot of us on the Bachmann forum are not familiar with the workings of the digitrax system, so your last resort is a friend or someone else in the area that has a digitrax DCC system.