Print Page - Build a T-Trak Track Aligner

Title: Build a T-Trak Track Aligner
Post by: hminky on July 03, 2018, 12:37:08 PM

Have a "What-I-Did" delving into aligning track on T-Trak modules:

http://www.chainsawjunction.com/n-scale/t-trak/aligner/ (http://www.chainsawjunction.com/n-scale/t-trak/aligner/)

(http://www.chainsawjunction.com/n-scale/t-trak/aligner/image/DSC_0011.JPG)

PDF version at:

http://www.chainsawjunction.com/n-scale/t-trak/aligner/aligner.pdf (http://www.chainsawjunction.com/n-scale/t-trak/aligner/aligner.pdf)

Thank you if you visit
Harold

Title: Re: Build a T-Trak Track Aligner
Post by: Len on July 03, 2018, 01:01:20 PM

Why not add a piece to the lower front edge of the board so it can be clamped to the edge of the module?

Len

Title: Re: Build a T-Trak Track Aligner
Post by: hminky on July 03, 2018, 01:07:52 PM

There are two of them and they don't need to be clamped.

Looseness helps.

(http://www.chainsawjunction.com/image/ttrak_1.jpg)

On corners it would detrimental.

(http://www.chainsawjunction.com/n-scale/t-trak/aligner/image/DSC_0013.jpg)

And most T-Trak construction methods don't have a good clamp area:

(http://www.chainsawjunction.com/n-scale/image/t-trak3.JPG)

Harold

Bachmann Online Forum

Discussion Boards => N => Topic started by: hminky on July 03, 2018, 12:37:08 PM