MY BACHMAN ALCO DEISEL, DCC QUIT RUNNING....THE SOUND CARD STILL OPERATES. OTHER DCC TRAINS RUN. I TRIED REPROGRAMING, BUT STILL WON'T RUN
It would appear that your caps lock key is stuck.
Have you tried resetting it to the factory defaults? Can you hear anything while trying to use it. Have you taken the shell off to see if the motor turns? Are the pickups making contact with the wheels.
Regards
c
Cap locks off. I get sound, and bells and horn works, plus engine noise...but won't run. I'll examine the pickups. Thanks J
What DCC system are you using? Try resetting the decoder to factory default. Programm 8 into CV8. Exit programming,lift the loco off the track for a couple of seconds, put loco back on track. If resetting took place, the headlights will flash several times. Try running on address 3. I had a loco with a Tsunami do the same thing and did a reset. Joe
you say the sounds are still there. when you try to run this engine, does the sound throttle up when you adjust the speed controlller? if not, you are probably trying to run the wrong address. in a sound locomotive, the sound automatically runs on dcc unless you mute it, but it will only idle unless you have it properly addressed to the controller.
might check and see if the drive shafts are in place or a wire pulled off to the motor after you open it. might be your next step
Dave
If the bells and horns work. He's got the right address and the pickups are working fine