...and if you'd just answer the question or otherwise stay silent, we'd all be better off

I have identified the functions of the wires on the decoder side with the help of Tsunami, but still uncertain which pin does which function on the loco side with the female plug receptacle. I was told to test with a 3 volt battery, but want to be certain not to fry the board....any help appreciated.

Does it really matter??? I was asking legitimate advice on weighting and in turn you want to give me an English lesson. No matter what kind of forum I have ever visited, there's always the trolls that take the discussion into crap with nonsense.

That is a military Tank....not tanker....if youre not here to provide help,then dont bother posting

I say tanker...who cares...please don't start with the political correctness bs here...no one really cares.

Sort of what I was thinking....some say lead shot, but I do not have any....maybe could use BBs? ...and glue.

Whats the best way to add weight to tankers and still keep it hidden?

Whats a good economical power supply for lighting on the layout? I have been using old cell phone chargers since the put out between 6-8 volts mostly. What are your suggestions?

I have a Bachmann Item# 52401  HO 2-8-4 Berkshire Steam Loco DCC/Sound that the wiring between the loco and tended has pulled out of both harness plugs. I have purchased both replacement 2 pin and 4 pin plugs with harness, but I cannot find a wiring diagram anywhere that shows which wire goes where. The circuit board/decoder board inside the tender says soundtraxx. All the wires I am speaking of (there are 6 total) connect to this board, but I have no way of know how to match up to the new harnesses. Can anyone help? If so, email me at rstroud66@gmail.com.