Hi All.
I am currently using the Bachmann EZ Command on my modest layout, however, I have, and am planning, more DCC turnouts than the unit can support and thus to my question: How many DCC turnouts can the Dynamis system control? I am looking at a maximum of 20 DCC turnouts.
All the best.
Reinhard
the manual , on page 15, states
"Adresses up to 100 (25 decoders) can be supported."
http://www.bachmanntrains.com/home-usa/ez_content/dynamis_manual.pdf
Quote from: jbsmith on June 13, 2010, 11:45:10 PM
"Adresses up to 100 (25 decoders) can be supported."
What does that mean in terms of number of turnouts? Does each of those 25 decoders have 4 outputs? How many outputs does it take to operate a decoder? I could guess two outputs to drive a dual solenoid decoder, but how about stall motor decoders like the Tortoise?
Jim
Hi Again.
The turnouts that I am using are the Bachmann DCC type. I am able to operate 8 of these (independently) with the EZ Command. I am not sure as to the number of decoders in each turnout (I was under the assumption 1 each). Would the Dynamis be able to control 20 Bachmann DCC turnouts in the same fashion as the EZ Command?
Thanks again, and all the best.
Reinhard
I would say yes.