I am successful programming all four of my ez track dcc turnouts on my dynamis controller.
But when I turn everything off, it doesn't retain the programming that took place prior to shut down.
This just happened recently.  I operated the past year successfully, but now it won't remember.

Do I need more power.....booster perhaps?

Any advice would be appreciated.

RJ Walter

Can Bachmann's EZ DCC track turnouts be programed and used with NCE or MRC's Dcc systems?
If so both types of connections?....directly connect via a wire or wireless?

Has anyone added a sound decoder to the Bachmann HO Spectrum HHP-8 w/DCC, Amtrak/Acela?
If so, please pass on the specs to a decoder that is compatible.  Thanks!

Does anyone know if there is a sound version for the HO Spectrum HHP-8 w/DCC, Amtrak/Acela #651
coming out in the near future?

At the present time I have only ran Bachmann DCC trains with my EZ command Dynamis wireless DCC controller.
I'd like to purchase the following:

Kato HO 376582-LS EMD F40PH with Ditch Lights, Amtrak Phase III #396 (Kobo Shop Exclusive with DCC and ESU Lok Sound)

Does anyone see any issues with running this particular locomotive with my Dynamis DCC setup?

Thanks-RJW

I have connected two separate (non-connecting) layouts to my Dynamis command station.
One layout is connected to the 3.5mm jack-running two trains.  The other layout is connected
to the screw terminal.  Each layout covers an 8ft. x 8ft. area, with 2 DCC turnouts on each run.

Each layout measures 14.5 volts consistently around the layout.

Is there any potential problems with this type of configuration?  Is it safe to connect both outputs
to the two layouts? It seems to be running fine. I'm able to run 2 trains on each layout with the handheld.

Thanks, RJW