Hello, everyone. Is there a good aftermarket source for Bachmann drive parts?  I picked up an old Spectrum 2-8-0 (DC) on eBay that runs great, but a previous owner had dropped it and one of the rear drive wheels has a bent wheel center/ hub. I've been watching Bachmann's parts website since March for the wheel sets to come back in stock, but they haven't been restocked yet. I've tried eBay, but haven't found any listings.


On a similar note, I also have an old Plus Series 2-8-0 that has what appears to be one or two bent wheels. These wheels wobble a fair amount when running; the locomotive waddles pretty strongly down the track. I don't know if I can try to straighten them, but I'd like to find a replacement known-good wheel set if any are available. I've tried eBay for these too, but have only found the phase 2 style (round stubs and white plastic axles, as opposed to the Plus Series square axle centers).  I'm sure this one is a long shot, but I thought this was the place to ask.

Hi everyone.  I have an old (white box vintage) Bachmann 2-8-0 with the motor that is built into the cast frame of the locomotive.  I believe that this is pre- Plus Series, if I understand my research right.  It has the round wheel stubs that fit into the plastic axles, rather than the square ones.  It's been a decent runner up until recently, following an axle repair and light gear lubrication.  It doesn't seem to want to run at slow speed anymore.

A couple months ago, one of the plastic axles cracked as is typical for these models.  I took it apart and fixed it, and decided to clean and re-oil the gears while I had everything apart (it hadn't been re-lubed in years).  The axle journals were overly wet, so I cleaned and dried the frame and re-lubricated the journals with a more conservative amount of oil (Labelle 108).  When I reassembled the locomotive, it all of a sudden seemed to have lost its ability to pick up low voltage or something.  It still runs good at cruising speed, but won't crawl at slower speeds anymore like it used to.  It's the same whether starting up or slowing down.  When slowing down, it slows to a point and then shuts completely off (motor and headlight).

I have another 2-8-0 of the same vintage that runs fine at slow speeds.

Does this sound like an electrical pick-up issue, or is there something else that I should check?  Should I have used something else to lubricate the gears between the frame halves?

I know it's an old model, but it's been the favorite in my collection since I started getting into the hobby around 2002.     I just run on oval with DC using a Railpower 1370.