I just bought a large lot of EZ Track and a new 4-pack card of these "auto-eversing" tracks came with it.  There are no instructions with it.
I'd appreciate any information anyone can give me on using these.  Do I need specially equipped engines or powered units or can any DC locomotive use these?
Thanks for the help.
Mark

Hello EZ Trackers!  I'm new to EZ Track so I would appreciate some advice.

What is the center to center gap between the parallel straights on the EZ Track left and right crossovers?  Which parallel (concentric) curves would match up to that gap?   I run longer equipment so 18 inch radius is out.  22 inch radius is the absolute tightest I can go and larger, 26 and 28, are better.
Also, what would be the center to center gap between parallel lines if two #5 or #6 turnouts were used?  Is there a book or publication that would have all this information?
Thanks for the help.
Mark