Hello
I am using this controller and don't know if there is any danger of running one dcc loco and one dc loco on the same track at the same time. This controller has analog and dcc both does the separate controlls eliminate the chance for engine damage or is it best to just use one or the other.
There is NO danger running both at the same time. However a word of cautiion, do NOT leave the DC loco idling on the tracks as you can burn out the motor. It may over heat if it is not moving, no air to cool the motor.
Regards
c ;)
OK Thanks for the answer...............
Hello, is it possible to control Accessory turnout decoders with EZ command control station?
Regards!
Try this link, I think it has the answers you are looking for:
Fitting EZ Command® to your System/DCC FAQ's - Bachmann
www.bachmann.co.uk/service/dcc3.php
:)
Regards
c