Bachmann Online Forum

Discussion Boards => Williams by Bachmann => Topic started by: jerrskog on May 15, 2013, 05:04:38 PM

Title: smoke unit
Post by: jerrskog on May 15, 2013, 05:04:38 PM
I have a Williams Berkshire 2-8-4 stock #BERK116. The smoke unit is not working. It says  it has a seuthe smoke unit. Where can I get a replacement?
Title: Re: smoke unit
Post by: richg on May 15, 2013, 06:09:00 PM
Did you check the Parts Page?

Rich
Title: Re: smoke unit
Post by: phillyreading on May 15, 2013, 06:20:14 PM
You should be able to get a seuthe smoke unit from the parts people. I replaced one on an S-2 steamer, be sure to get it with the wire harness piece that fits into the circuit board or you will have to cut and solder wires.
To remove the seuthe unit from the smoke stack you just push it out, might be a little tough at first but it is just pushed in. Also make sure it has no smoke fluid in it before you remove it.

Lee F.
Title: Re: smoke unit
Post by: jerrskog on May 26, 2013, 03:03:09 PM
I ordered and installed the Bachmann recommended smoke unit. It was different than the original and did smoke a little. It is the worst smoke unit I have ever seen. If puffs very little smoke. A waste of $25!
Title: Re: smoke unit
Post by: phillyreading on May 26, 2013, 07:45:26 PM
See if Joe S. can help you with an electronic circuit or a few parts to decrease voltage to the motor and that should give you more smoke from the smoke unit.
He is on this forum as well.

Lee F.
Title: Re: smoke unit
Post by: Joe Satnik on May 27, 2013, 12:35:01 AM
Dear jerrskog,

http://www.bachmanntrains.com/home-usa/board/index.php/topic,13633.15.html

Hope this helps.

Sincerely,

Joe Satnik
Title: Re: smoke unit
Post by: jerrskog on May 28, 2013, 11:32:55 AM
Dear Joe:
       I didn't see anything at that site reference regarding the smoke unit.
Thanks,    Jerry
Title: Re: smoke unit
Post by: Joe Satnik on May 28, 2013, 03:20:58 PM
Hi, Jerry.

Reducing the voltage to the motor (but not the rest of the loco) means that you will have to increase the voltage to the tracks

(raise the throttle setting) to keep the same speed. 

An increase in voltage to the tracks gives you brighter headlights, brighter passenger car interior lights,

and more power to the smoke unit, which will run hotter and produce more smoke.

As an added bonus, you will have better low speed control.

The only disadvantage is that your top speed may be reduced from 147 scale mph (Classic Toy Trains review, Dec. 2001)

down to perhaps 120 scale mph. 

To put that into perspective, the max operating speed of the Acela Express is 150 mph, but averages 70 mph in the Northeast Corridor. 

According to Wiki, "... (the Acela trains) rarely exceed 60 mph at any time through Connecticut until reaching New Haven.

Ironically much of this track runs parallel to the highway so Acela passengers can see automobile traffic passing by often at 70 mph. " (End quote.)

As an alternative, you could install an aftermarket voltage-regulated smoke unit.

Hope this helps.

Sincerely,

Joe Satnik