What is the best glue for polyurethane resin?
Gene
Dear Gene,
Found this link:
http://www.epicresins.com/
Here's what I was looking for !
http://www.thistothat.com/
Hope it helps.
Best Wishes,
Jack
Gene....
For any resin kit, I use CA adhesive with a kicker to cure it.
Sid
Dear Sid,
Thanks for the response. I'll remember that one. I use lots of CA with Zip Kicker for model airplanes, etc. Works well. We do not build museum pieces, so only use the medium weight or so. I remember one time TOC mentioned that CA can be softened and removed by soaking in water.
Have you ever tried Gorilla Glue for models? I use it a lot to repair outside broken bird baths, etc, but the stuff expands greatly when water is applied. "Strong stuff," as Elwood Blues said !
Best Wishes,
Jack
Thanks all.
I find that No-Nails covers just about any gluing job I need to cover.
Don
Dear Grumpy,
Is all this stuff "instant grab" or do you have some working time? I would hate to connect the "neck bone to the leg bone," and not have the time to correct it. :)
Too, can you get it at Lowe's or similar?
Best Wishes,
Jack
The No -Nails has good holding power until it dries. You have 30 min working time . I use little dobs to hold small things in place. My back ground panels are all held it into place with No-Nails.
Don