Just bought a SD45 spectrum DCC ready,( n scale) opened it up to install a chip and i have no idea of what hole in pc board is what.( #1-#8) Where can i find the info ,not with loco and have`t found it on the board. Thanks Joe
I had the same problerm with the HO Freedom Locomotive. I finally found a small #8 on the board and the instruction sheet had a little box in the lower corner showing the angle of the clips. I used this as a reference and it worked fine. At least in HO scale I could see the number. Maybe N scale is different.
LIRRMAN
Thanks for the info ,found the diag back in 07 posting. thanks again Joe