Hello.
I am new to this forum so please pardon me if I am not posting to the correct section.
I was repairing a 4-6-0 Anniversary Edition. It doesn't run. When I move it forward on the controller, it goes about half an inch and stops. Put it in reverse and it does the same thing. Checked the voltage on the rails and it is getting 5 to 6 volts. In one of the forums, I read it could be a gear issue. So I opened it to check the gears and it looks good. While doing so, I inadvertently broke one of the CONNE-10145 off of the Contact G812X-MT010. I have sent couple of emails to the Parts department but got no reply. How can I fix this? Thank you.
I am new to this forum so please pardon me if I am not posting to the correct section.
I was repairing a 4-6-0 Anniversary Edition. It doesn't run. When I move it forward on the controller, it goes about half an inch and stops. Put it in reverse and it does the same thing. Checked the voltage on the rails and it is getting 5 to 6 volts. In one of the forums, I read it could be a gear issue. So I opened it to check the gears and it looks good. While doing so, I inadvertently broke one of the CONNE-10145 off of the Contact G812X-MT010. I have sent couple of emails to the Parts department but got no reply. How can I fix this? Thank you.