I was given a Bachmann DCC Digital Commander Set as a gift, and I'm having difficulty programming either of the two engines to a different address. Otherwise, both locomotives seem to work fine. Both locomotives run smoothly forward and backward responding nicely to throttle adjustments. Unfortunately, I cannot run both at the same time since both are assigned to address 3 and I'm unable to change either one. I have gone through the steps in programming a locomotive to a specific address several times but to no avail. With only one engine on the track, I run it for a short distance then simultaneously press '3' and 'stop', and release them at the same time. The programming light under the stop button blinks, but then neither locomotive responds to a different address. Am I missing a step, or am I doing something wrong?
Any help is greatly appreciated. Thank you.
Dear John,
Think "Control, Alt, Delete". First press the 3, then stop, then release at the same time. Next press a new address, the loco will move slightly, and you're all set.
Have fun!
the Bach-man
Thank you Bach-man; worked great.