I need a little help with my On30 Shay. The engine was purchased new and will only run in analog. It will not respond to command changes from either a Bachmann EZ Command or a Digitrx DCS50.
Yes, I have built and use an isolated test track with a PTB100 Programming Track Booster and still the engine will only respond to analog. Also, I have tested other Bachmann engines on this track and they all respond to any and all commands. When using the Digitrax DCS50 I keep getting the error messages of DNA or DNR when trying to change the decoder address.
I also, tried to reset the decoder card by using CV8 and get the error code of DNR.
Any suggestions or help.
My Question Is: Can I obtain a new decoder card and install it myself? Thanks for any HELP.
Did you verify that you have a decoder installed? And if so, is it installed correctly?
-John
The Shay came in two versions......DCC ready and DCC/Sound equipped. If it doesn't have sound, it didn't come with a decoder installed. DCC ready version's product # starts with 25. Sound version product # starts with 28. The decoder ( if it has one ) is located under the coal load in the rear bunker. Please let us know which version you have.