How do I operate my Bachmann DCC turnouts with a Digitraxx"Zepher" control box. I have called Digitraxx and they had no answer.
You got a really nice manual with your Zephyr. If you'll look in section 24 that begins on page 34, you'll find the answer to your question.
Sir, I have read that section until I'm blue in the face and I have followed the directions as best I could and nothing happens when I go from c to t in the switch mode. Bachmann tells me in the turnout info that the switches are programmed to operate on 3 and I enter 3 in the switch mode and then throw it but nothing happens.
You can see if your question is answered here: http://tsd.digitrax.com/ (http://tsd.digitrax.com/) -Digitrax Tech Support Depot Link
Or contact Digitrax by by email at:
[email protected]If that doesn't work you are likely out of luck because a lot of us on the Bachmann forum are not familiar with the workings of the Digitrax system, so your last resort is a friend or someone else in the area that has a Digitrax DCC system.
rtoisme,
I have a Zephyr but use all manual throw turnouts so I don't know either. However, there is a group that most likely does. That is the Digitrax Yahoo! group. You can find them at:
http://groups.yahoo.com/group/Digitrax/ (http://groups.yahoo.com/group/Digitrax/)
Jim
Thank you for responding