Print Page - E-Z command loco. addresses

Title: E-Z command loco. addresses
Post by: mechanic on June 10, 2010, 08:56:54 PM

I was wondering if anyone knows what address corresponds to the numbers on the e-z command controller?
If I program a locomotive to button #1 and button #8 on my e-z command and later take my locomotives to a friends layout that uses MRC's prodigy advanced 2 what addresses are they? What do Bachmann's loco buttons correspond to on other systems is what I want to know,I think.
Thanks for any replies.
Eric

Title: Re: E-Z command loco. addresses
Post by: Jim Banner on June 10, 2010, 09:30:13 PM

Bachmann E-Z Command addresses 1 through 9 correspond to standard addresses 1 through 9. However, Bachmann E-Z Command address 10 corresponds to address 0 on those systems that support analogue (dc) locomotives.

If you have a dc power pack plugged into the E-Z Command, then the dc pack runs analogue locomotives and E-Z Command address 10 becomes standard address 10.

Jim

Title: Re: E-Z command loco. addresses
Post by: mechanic on June 11, 2010, 04:30:23 PM

Thanks Jim!

Bachmann Online Forum

Discussion Boards => General Discussion => Topic started by: mechanic on June 10, 2010, 08:56:54 PM