Print Page - HOW DO YOU FIGURE OUT TO HARD WIRE A DECODER INTO A STANDARD BACHAMNN LOCO

Title: HOW DO YOU FIGURE OUT TO HARD WIRE A DECODER INTO A STANDARD BACHAMNN LOCO
Post by: RUWINSKI45 on August 13, 2010, 11:47:04 PM

SINCE ALL THE WIRES IN A STANDARD BACHMANN DIESEL ARE THE SAME COLOR HOW DO YOU HARDWIRE A BACHMANN DECODER INTO A NO DCC READY LOCO? THE DECODER HAS COLORED WIRES & THE ENGINE HAS ONLY RED & BLACK. DO YOU REMOVE THE BOARD IN THE ENGINE NOW? ENGINE'S IN QUESTION ARE GP 40 & GP38 NOT DCC READY.

Title: Re: HOW DO YOU FIGURE OUT TO HARD WIRE A DECODER INTO A STANDARD BACHAMNN LOCO
Post by: Doneldon on August 14, 2010, 12:00:40 AM

45-

Easy. First, make sure that your motor and its electrical terminals are isolated from the loco's frame. Then you connect the wires coming from the wheels to the inputs on the decoder, attach the decoder's motor outputs to the motor, and use the other wires for the lights and other functions. The details on how to do this are contained in your decoder's instructions. Use that to see exactly what wire to connect to what. That's why they include the instructions.
-- D

Title: Re: HOW DO YOU FIGURE OUT TO HARD WIRE A DECODER INTO A STANDARD BACHAMNN LOCO
Post by: RAM on August 14, 2010, 12:04:57 AM

You can find a lot of help by going to www.tonystrains.com

Title: Re: HOW DO YOU FIGURE OUT TO HARD WIRE A DECODER INTO A STANDARD BACHAMNN LOCO
Post by: mabloodhound on August 14, 2010, 09:18:15 AM

Suggest you don't type in all capital letters. That's considered rude and shouting. Besides being difficult to read.

Title: Re: HOW DO YOU FIGURE OUT TO HARD WIRE A DECODER INTO A STANDARD BACHAMNN LOCO
Post by: MPSOUTHERN on August 15, 2010, 10:58:24 PM

After buying a Bachmann set with GP-40 at a good price, I installed an NCE DA-SR decoder for about $20.00.I thought the installation was simple and I am pleased with the results.

Bachmann Online Forum

Discussion Boards => HO => Topic started by: RUWINSKI45 on August 13, 2010, 11:47:04 PM