Hey everyone, I bought a couple of Jackson Sharp excursion cars, and I was wondering if it's possible to add figures to them easily. IE, is there a way to remove the roof? I see tabs, but I don't want to break the cars.
Thanks
(http://www.trainboard.com/railimages/data/500/SC_N_first_set_002.JPG)
It is not hard to get off the roofs. I just pulled on mine. I have three. If you find a spot where the factory used a bit too much glue, you can always use your eXacto knife. The figures are from Model Power, Merten and Preiser. I used Mikro Kristal Kleer, from Microscale, as glue. I found that you do need tweezers to put the figures into the seats. A dot of MKK on the seats of the pants/skirts is usually enough glue to keep the figure in its seat.