I have a DCC Spectrum Consolidation. Often times when I try to reverse the engine into a siding on my layout, the tender derails. I think it is because of the wires being close to the draw-bar and not allowing it to swivel normally. Is there anything that I can do about this problem?
Nothing to do with the DCC.
If it's the wheels closest to the locomotive, give the wires a little more slack, gently tug on them and do what I've done to all my tenders. I add a little weight under the coal at the front end of the tender. I use washers just a tad smaller than the coal pile. Works a treat. :-I