I purchased two HO DCC Turnouts. One had instructions with it on how to program the address. This turnout had a reset button and I was able to program it as F5. The second DCC Turnout did not have an instruction sheet and there was no reset button. I figured out that the address was F2. I tried programming it the regular way but could not change the address. Is this Turnout programmable? If so, how do I program it?
thanks
rich927
Both Turnouts are made by Bachman. They are standard Turnouts. One Left hand turnout has a Programming button. I t's Product ID is H4561B-L. The other Turnout has a Product ID of H4561B-L. As I write this, I have discovered that this Turnout does have a Programming button after all. It was covered up by a small piece of plastic. The other one did not have the button covered over. So, I figured it out after all. Thanks for the help. (My bad).
rich927 :-[
Thanks for posting your findings. It could very well help the next guy with the same problem.
Jim