Hello,
Searched the old post and came up empty. I want to use the 0n30 trolley chassis/motor for a On30 critter.
Has anyone installed DCC into the trolley? Any tips that can be shared?
thank you
c gleason
It's really a straight forward installation I found nothing tricky about it, it's really basic inside.
I do recommend making you wires long enough to bundle nicely so you can mount it were you need inside, I did mine half heartedly because it's just to run around a Christmas layout so I was not concerned with seeing the decoder if you looked inside, as a result I ended up cutting a section of floor out so I could get the decoder and wires to sit flat. other then that stick the clear roof screws to a magnet so you don't lose them they are VERY TINY.
Good luck
NM
(http://i792.photobucket.com/albums/yy202/NarrowmindedRR/photo-7.jpg)