Print Page - Screw Thread

Title: Screw Thread
Post by: Broken Shay on August 27, 2011, 06:21:20 PM

Hello,

need to tap a couple new holes on a shay to fit the 10597 screws. Can anyone tell me what the size is?

thanks in advance

John

Title: Re: Screw Thread
Post by: Jim Banner on August 29, 2011, 12:30:14 AM

Can you tell me which screws those are? That is, what they hold together? I have my Shay available but the diagrams for it are packed away while I am finishing off my new shop.

Jim

Title: Re: Screw Thread
Post by: Broken Shay on August 30, 2011, 12:39:10 PM

Thanks

It is the screw that holds the motor to the frame

John

Title: Re: Screw Thread
Post by: Jim Banner on August 30, 2011, 11:03:35 PM

I make it M1.6 x .35

Jimi

Title: Re: Screw Thread
Post by: Broken Shay on September 02, 2011, 01:28:41 PM

Jim,

Thank You, I will now go on the quest for a matching Tap.

Thanks again

John

Bachmann Online Forum

Discussion Boards => On30 => Topic started by: Broken Shay on August 27, 2011, 06:21:20 PM