Text only | Text with Images

Bachmann Online Forum

Discussion Boards => HO => Topic started by: Mr.G on October 03, 2011, 08:32:56 PM

Title: Resetting a decoder with the E-Z command
Post by: Mr.G on October 03, 2011, 08:32:56 PM
Hi,

Is there a way i can reset a DCC decoder with my Bachmann DCC E-Z command controller? I heard that this was possible but don't know how.

Any help would be appreciated,

Thank you.
Title: Re: Resetting a decoder with the E-Z command
Post by: richg on October 03, 2011, 08:55:46 PM
Check your manual that came with the set. I believe the manuals are in the Bachmann site here also.
With the brand of controller I use, CV8, enter 8.

Rich
Title: Re: Resetting a decoder with the E-Z command
Post by: richg on October 03, 2011, 10:50:22 PM
I took time to download and read the EZ Command manual right off the Bachmann site and it does not say anything about resetting a decoder.
I have to assume the OP means the original EZ Command and not the Dynamis.
The few DCC systems that I have seen so far have a digital display to do CV programing/reseting and reading back the CV's.
My old MRC 2000 DCC system was like the EZ Command with even less features. I could program a loco number but not reset decoders.

Rich
Text only | Text with Images